How to remove a radiator
Removing a Radiator for Decorating
How to remove a radiator when decorating
Isolating The Radiator
First job to do is to isolate the radiator, this can be done by turning both of the radiator valves fully off, this can be done with the valve knob and finishing off with an adjustable spanner (don’t over tighten).
If you have thermostatic radiator valves (TRVs) you will need a shut off cap to push the pin fully down, these would have come with the valves when new, without them it is very hard to shut off the valve and you will normally end up draining the complete system. (See draining and refilling central heating) try YouTube.
Draining The Water
There are many gadgets on the market to do this but all you need is an old ice cream tub, you may find it fits better if you cut a slot for the valve, but in this case it fits perfectly.
Supporting the valve with a pair of grips loosen the nut which holds the valve to the radiator, the water will then drain into the ice cream tub, open the bleed valve to let the air in to speed things up.
There will not be enough room in the tub for all the water, so either keep emptying with a cup or re-tighten the nut and drain the tub.
Once the water stops running out, undo the other end and lift the radiator up and off the brackets, there will still be a small amount of water in the radiator so protect any carpet and have a suitable bowl to pour the water into.
You may find that one of the valves drips slightly after removing the radiator and needs to be tightened
Remember when tightening the nut to always support the pipe as it can bend and crack the seal.